Showven SPARKULAR WHEEL User Manual page 18

5. Programming and Firing
a) Programming SPARKULAR
b) Heating up, it takes few minutes, it varies according to the voltage and environment
temperature.
c) Make sure the prescribed safety zone of related firing sequences are clear.
d) Suggest to clear material for SPARKULAR
e) Firing. In order to prevent overheat in the heating chamber and protect machine, the
maximum continuous firing time for SPARKULAR
f) The operator should always have a clear view of the device, so that he/she can stop the
show immediately when there is danger.
g) Running preset sequence No.1 to clear material for SPARKULAR
material will remove the remaining particles from heating chamber.
6. Turn Off and clean up
a) Power off SPARKULAR
b) Disconnect all POWER and DMX cables.
c) Empty the remaining HC8200 in hopper, and store the remaining HC8200 in a dry sealed
bottle for next time use. Never touch the output nozzle of SPARKULAR® WHEEL when
empty the hopper. DANGER OF GET BURNT!
d) Operators can use handheld vacuum cleaner to empty the feeding hopper. Do make sure
the machine was cool down when clean it. Do NOT use high-power vacuum cleaners to
avoid hot consumables being sucked into the vacuum cleaner from the heating chamber
and cause fire.
e) Clean the surroundings to remove powder residues.
Maintenance
Δ
a) Empty the feeding hopper before shipment of machine.
b) Empty the feeding hopper if long time not use, for high humidity environment we suggest
to empty feeding hopper after each show.
c) Clear material both before and after the show.
WHEEL, set the firing sequences etc.
®
WHEEL before firing.
®
WHEEL, allow SPARKULAR
®
WHEEL is 180s.
®
WHEEL after show, clear
®
WHEEL to cool down.
®