Table of Contents
Advertisement
Recline Adjustment
To adjust recline, release tension of LATCH or
vehicle belt then turn knob on front of base
until desired angle is achieved (Fig. D).
•
When correctly reclined, the red line on base
will be parallel to level ground.
•
If there is a problem stabilizing the base,
place a rolled towel in the crease of the
vehicle seat to help level the base.
WARNING!
described above. Do not raise the base
off of the front edge of vehicle seat; doing so
will reduce the protection for your child.
Attaching Restraint to Base
To install, align restraint rear facing with slots in
base, then push down until it clicks into base
(Fig. E). Pull up from child restraint handle to
be sure it is properly secured. Rotate handle to
"in vehicle position".
WARNING!
to base unless the base is secured in a
vehicle as described on pages 20-25.
Removing Restraint from Base
To remove child restraint from base, squeeze and hold release handle on
the rear of the restraint, then lift restraint by handle (Fig. F).
Only raise base as
Never attach restraint
Using the Restraint
D
E
F
13
Advertisement
Table of Contents
