Table of Contents
Advertisement
Base Installation
Lap-Shoulder Belt Installation
•
Figure A illustrates a typical rear facing lap-
shoulder belt installation.
•
If attached, remove restraint before installing
base.
•
When not in use, always store the LATCH connectors
on storage ring at front of base.
1.
Place the base in a rear-facing position on the
vehicle seat with the anti-rebound bar against
the vehicle seat back.
2.
Open lock-off by lifting both tabs, then open
lock-off plate (Fig. B).
3.
Extend vehicle belt.
4.
With shoulder and lap portion of vehicle seat
belt together, route under both belt guides
(Fig. C).
5.
Verify that the vehicle belt is not twisted, then
buckle (Fig. D).
6.
Adjust recline by turning knob on front of
base until correct angle is achieved.
•
When correctly reclined, the red line on base
will be level with the ground.
•
If there is a problem achieving the proper recline
angle, collapse the recline adjuster and place a
rolled towel or pool noodle in the crease of the
vehicle seat to help level the base.
WARNING!
raise the base off of the front edge of vehicle seat; doing so
will reduce protection of your child.
22
Only raise base as described above. Do not
A
B
C
Advertisement
Table of Contents
