Table of Contents
Advertisement
Child Seat Functions
Storing the LATCH Connectors
When the LATCH connectors are not in use, lift
the child seat cover to access LATCH storage
slots (Fig. A). Fold each end of the LATCH
strap and slide each LATCH connector into the
adjacent slots.
NOTE: Child seats are shipped from Britax with
LATCH connectors in the storage slots.
Recline Adjustment
Pull the recline handle then slide the child seat
shell into the desired position. (Fig. B) Release
the recline handle and verify the child seat has
locked into position.
NOTE: It will be necessary to loosen the tether,
vehicle seat belt, and/or LATCH strap before
adjusting the recline position. The tether,
vehicle seat belt, and/or LATCH strap must be
properly re-tightened after adjusting the recline
position.
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two
halves together until a positive click is heard
(Fig. C).
Releasing the Chest Clip
Squeeze the middle tab together and pull apart
the two pieces (Fig. D).
Adjusting the Chest Clip
Slide chest clip up or down on harness so it is
positioned at the middle of the child's chest,
level with the child's armpits.
30
A
b
c
d
Harness Buckle
Fastening the Harness Buckle
Hold the harness buckle with one
hand. Use the other hand to insert
one buckle tongue at a time into the
harness buckle (Fig. E).
Proper connection is confirmed with
a positive click after inserting each
buckle tongue.
Releasing the Harness Buckle
Brace the rear of the harness buckle
with one hand. Press the release
button and slide both tongues to
remove from the buckle (Fig. F).
IMPORTANT: Periodically clean
the harness buckle to ensure safe
operation. See page 37.
Child Seat Functions
e
x 2
f
31
Advertisement
Table of Contents
