Table of Contents
Advertisement
Child Seat Functions
Storing the LATCH Connectors
When LATCH connectors are not in use, lift cover to
access LATCH storage slots (Fig. A). Fold each end
of the LATCH strap and slide each LATCH connector
into the adjacent slots.
NOTE:
Child seats are shipped from Britax with LATCH
connectors in the storage slots.
Recline Adjustment
Pull the recline handle then slide the child seat shell into
the desired position. (Fig. B) Release the recline handle
and verify the child seat has locked into position.
NOTE:
It will be necessary to loosen the tether, vehicle seat
belt, and/or LATCH strap before adjusting the recline position.
The tether, vehicle seat belt, and/or LATCH strap must be
properly re-tightened after adjusting the recline position.
WARNING!
Child seat must be in the full
upright position when installed in forward-
facing mode with children over 33 pounds (15 kg.).
Infant-Positioning System
The Infant-Positioning System is designed to provide
better fit and comfort for infants using this child seat.
For additional side support, fold side flaps (Fig. C).
NOTE:
Remove after child can sit comfortably in child seat without
additional support.
Toddler Pillow
The toddler pillow provides extra head support and comfort for taller
children. Although the toddler pillow can remain installed through the life
of the child seat, it can be removed by unhooking each attachment clip.
30
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two halves
together until a positive click is heard (Fig. D).
Releasing the Chest Clip
Squeeze the middle tab together and pull apart
A
the two pieces (Fig. E).
Adjusting the Chest Clip
Slide chest clip up or down on harness so it is
positioned at the middle of the child's chest, level
with the child's armpits.
Slide HUGS™ pads and comfort pads to a
comfortable location for the child.
B
HUGS™ and Comfort Pads
IMPORTANT: HUGS™ (Harness Ultra Guard
System) pads must be installed for forward-
facing use. Removal of HUGS is optional for rear-
facing use.
C
Harness Buckle
Fastening the Harness Buckle
Hold the harness buckle with one hand. Use the other hand to insert
one buckle tongue at a time into the harness buckle (Fig. F).
Proper connection is confirmed with a positive click after inserting
each buckle tongue.
Child Seat Functions
D
E
F
x 2
31
Advertisement
Table of Contents
