Table of Contents
Advertisement
Base Installation
LATCH Installation
•
Figure A illustrates a typical rear facing LATCH
installation.
•
Verify that your vehicle is equipped with LATCH
anchors. If LATCH anchors are not installed, you
must use vehicle belt installation methods.
1.
Disconnect LATCH connectors from storage
ring on the front of the base.
2.
Press and hold the LATCH adjuster release
button, then pull to lengthen LATCH harness
to full length.
3.
Open lock-off by lifting both tabs, then
opening lock-off plate (Fig. B).
4.
Place the base sideways on the vehicle seat, with
the anti-rebound bar facing you.
5.
Verify that the LATCH harness is not twisted,
then attach the closest connector to the
seatback to the farthest LATCH anchor in
desired seating position (Fig. C).
•
A positive click confirms attachment.
6.
Rotate base into rear facing position with anti-
rebound bar against vehicle seat back.
7.
Verify that the LATCH harness is not twisted,
then attach the other connector to closest LATCH
anchor in desired seating position (Fig. D).
•
A positive click confirms attachment.
8.
Adjust recline by turning knob on front of base until correct angle
is achieved.
•
When correctly reclined, the red line on base will be level with the
ground.
20
A
B
C
Advertisement
Table of Contents
