Table of Contents
Advertisement
WARNING!
described. Do not raise the base off of
the front edge of vehicle seat; doing so will
reduce protection of your child.
7.
Push the base firmly into the seat while
removing slack from the vehicle belt (Fig. D).
8.
Close lock-off plate over the vehicle belt, then
secure by closing both tabs while pressing
firmly on the lock-off plate.
•
Lock-off is properly secured when tabs are flat
against lock-off plate.
9.
Check recline angle. If adjustment is necessary,
remove seat belt, adjust recline angle, repeat
entire process from step 3.
10.
Verify that vehicle belt is tight and that the
base is stable. Base is stable when it moves less
than 1 inch front to back or side to side.
Base Removal:
Remove child restraint from base, open lock-off, unbuckle vehicle belt
and remove vehicle belt from belt guides.
Only raise base as
Base Installation
D
E
25
Advertisement
Table of Contents
