Table of Contents
Advertisement
Part 1: For All FlexColor Users
Instant Approval Architecture
To change the approval status of any image, first select the image by clicking on it
once, then click on the appropriate button in the tool panel at the left side of the
window.
To filter the thumbnails by approval status, activate one or more of the filter buttons,
which are in the tool panel at the left side of the window (see Figure 1, above, and
Figure 2, below). The filters are additive, so if you enable both the green and yellow
filters, then you will see both green and yellow images. If you enable all three, the
effect is the same as enabling no filters.
Figure 2: Examples of reading and reading the approval filter in the thumbnails window.
Use the
pop-up menu to sort the thumbnails either by date or by name. You
Sort by
can further sort the images by approval rating by marking the
...and approval
check
box. When sorting by approval, all green images are shown on top, then yellow and
finally red; within a given approval rating, the images are sorted according to your
selection in the
pop-up menu.
Sort by
Approval Settings in the Preview Window
When you are working in the main FlexColor window, you can see the approval
rating of the current image at the bottom-left corner of the preview. To change the
rating, click on this rating icon. With each click, the rating will cycle from green to
yellow to red and back to green again.
FlexColor 4.5 Documentation Addendum
9
Advertisement
Chapters
Table of Contents
