Lan1/2 Enable/Disable; Watch Dog Enable/Disable; Usb Wake-Up - Supermicro SUPERSERVER 1015B-3 User Manual

S S
UPER ERVER 1015B-3 User's Manual

LAN1/2 Enable/Disable

Change the setting of jumper JPL1
and JPL2 to enable or disable the
LAN1 and LAN2 Ethernets ports, re-
spectively. See the table on the right
for jumper settings. The default setting
is enabled.

Watch Dog Enable/Disable

JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if
an application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog
Timer.

USB Wake-Up

This jumper allows you to wake up
the system by pressing a key on the
USB keyboard or by clicking the USB
mouse of your system. The JPUSB1
jumper is used together with the USB
Wake-Up feature in BIOS and both
must be enabled to use this feature.
See the table on the right for jumper
settings. Notes: The default setting
is enabled. Please be sure to remove
all other USB devices from the USB
ports whose USB jumpers are set to
disabled before the system goes into
standby mode.
LAN1/2 En/Disable Jump-
er Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
USB Wake-Up
Jumper Settings
(JPUSB1)
Jumper Setting
Pins 1-2
Pins 2-3
5-20
Defi nition
Enabled
Disabled
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled
Disabled