Table of Contents
Advertisement
LAN1/LAN2 Enable/Disable
Change the setting of jumper JD4
to enable or disable both onboard
LAN ports on the motherboard.
See the table on the right for
jumper settings.
ting is pins 1-2.
VGA Enable/Disable
JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for
jumper settings.
3rd Power Supply Alarm
Enable/Disable
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup.
If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP9 to prevent false
alarms. See the table on the right
for jumper settings.
Chapter 5: Advanced Motherboard Setup
The default set-
5-19
LAN1/LAN2
Enable/Disable
Jumper Settings
(JD4)
Jum per
Position
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
VGA Enable/Disable
Jumper Settings
(JP4)
Jumper
Position
Definition
1-2
Enabled
2-3
Disabled
Power Supply
Alarm Enable/Disable
Jumper Settings (JP9)
Jumper
Position
Definition
Open
Disabled
Closed
Enabled
Advertisement
Table of Contents
