Table of Contents
Advertisement
Chapter 2: Server Installation
Installing the Server into a Telco Rack
To install the SuperServer 1015B-3 into a Telco type rack, use two L-shaped brack-
ets on either side of the chassis (four total). First, determine how far follow the
server will extend out the front of the rack. Larger chassis should be positioned to
balance the weight between front and back. If a bezel is included on your server,
remove it. Then attach the two front brackets to each side of the chassis, then the
two rear brackets positioned with just enough space to accommodate the width of
the telco rack. Finish by sliding the chassis into the rack and tightening the brackets
to the rack.
Figure 2-6. Installing the Server into a Telco Rack
2-9
Advertisement
Table of Contents
