Sas/Sata Drive Bay Installation/Removal; Accessing The Drive Bays; Hard Drive Installation - Supermicro SUPERSERVER 1015B-3 User Manual

S S
UPER ERVER 1015B-3 Manual
6-4

SAS/SATA Drive Bay Installation/Removal

Accessing the Drive Bays

Hard Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace hard drives.
Proceed to the next section for instructions.
DVD-ROM Drive: For installing/removing the optional DVD-ROM drive, you will
need to gain access to the inside of the system by removing the top cover of the
chassis. Proceed to the "DVD-ROM Drive Installation" section later in this chapter
for instructions.
Note: Only a "slim" DVD-ROM drive will fi t into the 1015B-3.

Hard Drive Installation

The hard drives are mounted in drive carriers to simplify their installation and
removal from the chassis. These carriers also help promote proper airfl ow for
the drive bays. For this reason, even empty carriers without drives installed must
remain in the chassis.
Installing a Hard Drive into a Drive Carrier (Figure 6-3)
1. Insert a drive into the carrier with the PCB side facing down and the connec-
tor end toward the rear of the carrier.
Figure 6-2: Replacing a System Fan
(shown with optional fan installed)
6-4