Northern Telecom DMS-100 Series Maintenance Manual page 81

Network related user interface commands 6-5
JCTRS command
The JCTRS command accesses the NET JCTRS status level and displays the
status of the junctors in both planes of the specified network.
LINKS command
The LINKS command accesses the NET LINKS level for the peripheral
module (PM) links to both planes of a specified NM.
LOC command
The LOC command generates a message that gives the location of the
specified NM.
OFFL command
The OFFL command sets an NM to the offline state.
PATH command
The PATH command accesses the NET PATH menu and assists in speech
path maintenance. The PATH command is present only on switches with
feature package Switch Path Diagnostics (NTX885AB).
QTST command
The QTST command displays the current status of the NM under test.
QUIT command
The QUIT command is common to all NET maintenance menus. When you
enter the QUIT command, the command causes the level now displayed to
change to the next higher level.
Note: The QUIT command is not mentioned in other command descriptions
for the DSNE sections of this chapter. The QUIT command is common to
all NET maintenance menus.
RECOVER command
The RECOVER command returns all NMs to service.
RTS command
The RTS command tests an NM. If the NM is correct, the RTS command
returns the NM to service.
TRNSL command
The TRNSL command translates the NM number to the central message
controller (CMC) port number. The TRNSL command displays the number
of the CMC port. The NM is assigned to a numbered CMC port, which
TRNSL displays.
DMS-100 Family Networks Maintenance Guide BASE10