Northern Telecom DMS-100 Series Maintenance Manual page 60

3-12 Network-related logs
Table 3-1xxx
Network-related logs
Log name Causes
NET102 A receiving peripheral detects an
accuracy fault. An accuracy fault can
be a parity failure or an accuracy
mismatch.
NET103 The network subsystem generates this
report to summarize the accuracy
faults in the switch.
NET104 The network subsystem generates this
report when NET PATH diagnostics
find cards that have faults.
NET105 The network subsystem generates this
report when the AUTO NET PATH test
passes or is aborted.
NET106 Provides the status of the scheduled
NET PATH tests.
297-1001-591 Standard 04.03 March 1999
(continued)
Response
Collect and compare following
accuracy messages to determine the
cause of the accuracy failures. Use
the NET INTEG level of the MAP
display to assist in the process.
If any counter exceeds 80, refer to the
NET INTEG level of the MAP display to
investigate this potential problem.
Replace cards in the list of faults. Run
the NET PATH test again to check for a
correct replacement.
If the test is aborted, refer to the
ABORTED REASONS table for
NET105 to find the correct action. The
table is in the Log Report Reference
Manual . Repeat the test.
Test the paths manually. After batch
change supplement (BCS) applications
or restarts, the scheduled tests are
aborted. Implement the scheduled
tests again.
—continued—