Northern Telecom DMS-100 Series Maintenance Manual page 109

TRNSL command
Use the TRNSL command to determine which port of both message
switches (MS) links to the specified node by a fiber cable.
TST command
Use the TST command to run diagnostic tests on a single ENET node.
Another option is to use the command on all ENET nodes in a given plane.
System level non menu commands
The following commands do not appear on the system level menu. You can
enter the following commands as they appear on the menu.
The non-menu system level commands are as follows:
ABTK
DISP
LOADENALL
TRY
ABTK command
Use the ABTK command to abort an in-progress maintenance action on the
processing complex of an ENET shelf.
DISP command
Use the DISP command to display the current contents of ENET and system
levels of the MAP display. Use the DISP command to display the current
contents of the NET alarm banner. This command is for use on non-MAP
devices like Teletypes.
LOADENALL command
Use the LOADENALL command to load software into all ManB nodes on
one or both planes.
TRY command
Use the TRY command to determine which warnings will be displayed if
you enter a command. This command allows operating company personnel
to check the potential impact of a maintenance action before you perform the
maintenance action
Network related user interface commands 6-33
DMS-100 Family Networks Maintenance Guide BASE10