Northern Telecom DMS-100 Series Maintenance Manual page 113

QUERYEN command
Use the QUERYEN command to display information about a card slot in an
ENET shelf.
REXTST command
Use the REXTST command to control and query the parameters in operation
of the system-run REx tests. Use this command to run a manual REX test.
RTS command
Use the RTS command to return a minimum of one crosspoint card on the
selected shelf to service. If you specify one of the system cards on the shelf,
you can use this command to return the whole shelf to service.
The following system cards in an ENET node are important to operation of
the node:
NT9X31
NT9X30
NT9X13
NT9X26
NT9X36
NT9X40
If you return any system card to service in a manually busy node, the system
attempts to return the whole node to service.
SYSTEM command
Use the SYSTEM command to access the system level of the MAP display.
The system level of the MAP display allows operating company personnel
to maintain the ENET for each node.
TRNSL command
Use the TRNSL command to translate the location of an ENET crosspoint
card to the corresponding horizontal and vertical matrix coordinates of the
card. Use this command to display the MS ports associated with the node
that contains a system card.
TST command
Use the TST command to run a series of tests on the specified cards.
Shelf level non-menu commands
The following commands do not appear on the shelf level menu. You can
enter the following commands as the commands appear on the menu.
Network related user interface commands 6-37
DMS-100 Family Networks Maintenance Guide BASE10