Northern Telecom DMS-100 Series Maintenance Manual page 131

SNAPSHT command
Use the SNAPSHT command to capture data from the integrity or BERT
buffer. The command writes the data into the buffer for the path test level.
START command
Use the START command to initiate a test in the pending state.
STATUS command
Use the STATUS command to query test state information. Operating
company personnel can request state information for all tests, or for a
specified test. Operating company personnel also can request a display of
the names of all tests in a specified state.
STOP command
Use the STOP command to stop a test that is in the running state.
BERT level
The ENET BERT level of the MAP display provides a facility for operating
company personnel to perform network BERTS.
The BERT level supports the definition of eight BERT records. A maximum
of five of these tests can run at the same time. As a result, several users can
use BERT level at the same time.
To access the BERT level from the ENET, type
>BERT
and press the Enter key, or choose item 12 from the ENET command menu.
To enter the BERT level and automatically post a defined BERT test, type
>BERT test_number
and press the Enter key.
where
test_number
Figure 6-25 shows an example of a MAP display for the BERT level. Refer
to appendix E in table 15-4 for an explanation of BERT level status fields.
Network related user interface commands 6-55
is 0 through 7, to specify a defined BERT
DMS-100 Family Networks Maintenance Guide BASE10