Advertisement
Quick Links
®
iBoard
READ INSTRUCTIONS CAREFULLY BEFORE
START ING INSTALLATION. REMOVE CONTENTS
FROM BOX AND VERIFY ALL PARTS ARE PRE-
SENT. ASSISTANCE IS RECOMMENDED.
*BODY FRAME MOUNT
*NO DRILLING REQUIRED
PART LIST
iBoard
by APS
Driver Front Support
Bracket (DFS)
Driver Front Mounting
Bracket (DFM)
Driver Rear Mounting
Bracket (DRM)
Customer Support: info@iboardauto.com
®
Fastener Size
Tightening Torque (ft-lbs)
6mm
8mm
10mm
12mm
14mm
Front
Passenger Front Support
Bracket (PFS)
Passenger Front Mount-
ing Bracket (PFM)
Passenger Rear Mount-
ing Bracket (PRM)
1
PART#: IB-019&020
Required
6-7
√
16-18
X
31-32
X
56-58
√
92-94
√
Rev. 20210901
Advertisement
Related Manuals for APS iBoard
Summary of Contents for APS iBoard
- Page 1 ® ® iBoard by APS PART#: IB-019&020 Fastener Size Tightening Torque (ft-lbs) Required READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS √ FROM BOX AND VERIFY ALL PARTS ARE PRE- SENT. ASSISTANCE IS RECOMMENDED. 16-18 10mm 31-32 12mm 56-58 √...
- Page 2 ® Hardware Package A (For Bracket Installation) M12 Large Flat M14 Large Flat M12 Lock Washer M12X1.75-120mm Hex Bolt M12X1.75-30mm Hex Bolt M12 Hex Nut Washer Washer Hardware Package B (For Aluminum Step Bar Installation Only, Not Supply to Stainless Steel Step Bar)
- Page 3 ® STEP 3 (1) M12 Large Flat Washer (1) M12 Lock Washer (1) M12 Hex Nut Select Driver Front Support Bracket (DFS) and insert (1) M12X1.75-120mm Hex Bolt with (1) M12 Large Flat Washer through the mounting slot. Place (2) M14 Large Flat Washers onto the M12 Hex Bolt between the Support Bracket and the factory body mount, (Fig 2A &...
- Page 4 ® STEP 6 STEP 8 Once all (2) mounting brackets are installed, then proceed to Stainless Steel Step Bar Installation: the Step Bar installation. According to the style of Step Bar Select a Stainless Steel Step Bar (with the U-Sliders installed proceed to the correct installation STEPS.
Need help?
Do you have a question about the iBoard and is the answer not in the manual?
Questions and answers