Advertisement
®
iBoard
by APS
READ INSTRUCTIONS CAREFULLY BEFORE START ING
INSTALLATION. REMOVE CONTENTS FROM BOX AND
VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS
RECOMMENDED.
*ROCKER PANEL MOUNT
*NO DRILLING REQUIRED
Item
QTY
1#
6
Mounting Brackets
2#
12
M8 Hex Flange Nuts
M6X1-20mm Square Head Bolts
3#
12
iBoard
Description
3 #
2 #
Customer Support: info@iboardauto.com
PART#: IB-R094/R095/R952
Fastener Size
Tightening Torque (ft-lbs)
6mm
8mm
10mm
12mm
14mm
Item
QTY
4#
12
M6 Large Flat Washers
M6 Nylon Lock Nuts
5#
12
4 #
1
®
Required
6-7
16-18
31-32
56-58
92-94
Description
5 #
Rev. 20211001
√
√
X
X
X
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for APS iBoard IB-R094
Summary of Contents for APS iBoard IB-R094
- Page 1 ® iBoard ® iBoard by APS PART#: IB-R094/R095/R952 Fastener Size Tightening Torque (ft-lbs) Required READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND √ VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS 16-18 √ RECOMMENDED. 10mm 31-32 12mm...
- Page 2 ® iBoard Front Driver Passenger Customer Support: info@iboardauto.com Rev. 20211001...
- Page 3 ® iBoard STEP 1 STEP 3 Select a Running Board. Slip (3) M6x1-20mm Square Head Bolts into each bottom channel (Fig 2). Carefully position the Start installation on the driver side of the vehicle. Locate the Running Board onto the (3) Mounting Brackets. driver side front bracket mounting location.
- Page 4 ® iBoard STEP 4 Level and adjust the Running Board and fully tighten all hard- ware. Attention Important: Please follow the recommended Tightening Tor- Do periodic inspections to the installation to make ques shown in the table on page 1. Don’t over tighten, or sure that all hardware is secure and tight.
Need help?
Do you have a question about the iBoard IB-R094 and is the answer not in the manual?
Questions and answers