Verifying Server Node Failover; Configuring The Cluster For Netware 5.1 - Compaq CL380 - ProLiant - 256 MB RAM Software User's Manual

Compaq proliant cl380 software user guide
Hide thumbs Also See for CL380 - ProLiant - 256 MB RAM:
Table of Contents

Advertisement

Verifying Server Node Failover

When running the failover test, it is recommended to start with the least
complex test, so do not run any client activity while testing failover events.
For instructions on testing NHAS Failover, please refer to the Novell High
Availability Server User's Guide from Novell.

Configuring the Cluster for NetWare 5.1

Do the following preparations before installation.
1. Install all necessary NetWare Support Packs and Novell Support
Software Diskettes (NSSD).
2. Ten megabytes of free space that is not part of a Novell Storage Services
(NSS) or Device Driver Functional Specification (DDFS) partition on
the shared storage array is required for the split brain partition. Be sure
this partition can be readily seen through both server nodes.
3. Set up the redundant Network Interface Card (NIC) in the Compaq
ProLiant CL380 to connect to the main network link. Use
CPQANS.LAN to create fault-tolerant NICs in each server node.
NOTE: Refer to NSSD.HLP on the SmartStart and Support Software CD for additional
assistance on creating fault-tolerant NICs.
The NetWare Cluster Services (NCS) installation creates a new cluster object
and installs NetWare Cluster Services software on the server nodes you
specify to be part of your cluster. This installation is done from a remote client
workstation machine.
1. Insert the NCS CD into the CD-ROM drive on the client workstation
with administration rights to the directory tree to which the server nodes
reside.
2. From the initial splash screen, launch the NetWare Cluster Services
installation. Continue through the installation screens until you get to the
screen that prompts you to create a new cluster.
3. Select Create a New Cluster, then click Next.
4. Enter a name for the new cluster object you are creating and specify the
directory tree and context where you want it created. Then click Next.
System Setup and Configuration for Novell NetWare 3-9

Advertisement

Table of Contents
loading

Table of Contents