Compaq CL380 - ProLiant - 256 MB RAM Software User's Manual page 14

System Setup and Configuration for Microsoft Windows NT Server 4.0, Enterprise Edition 1-3
8. Press F10 to exit.
9. Select Step 5: Save and Exit, then press Enter and wait for the Compaq
Array Configuration Utility to start.
NOTE: The Compaq Array Configuration Utility configures the Integrated Smart Array
Controller. Refer to the Compaq Integrated Smart Array Controller User Guide for
additional information on using the Compaq Array Configuration Utility.
10. When the Compaq Array Configuration Utility starts, select Continue,
then click Next.
11. Click Next to select a controller configuration.
12. Select the desired RAID level and click Continue.
13. Click Finish.
14. The Product Selection window appears. Continue to follow the guided
installation process, selecting options as needed. If you need help, refer
to the online help by clicking on the Help button.
IMPORTANT: Microsoft Windows NT Server 4.0, Enterprise Edition, does not detect the
presence of both network adapters correctly in the Compaq ProLiant CL380. When the
operating system attempts to set up the network adapters, you will see information
pertaining to only one adapter. Uncheck the Intel 82557 based 10/100 Ethernet PCI
Adapter and leave the Compaq Ethernet or Fast Ethernet NIC adapters checked. Continue
installing the operating system. You will see correct settings for both network adapters in
the ProLiant CL380 in subsequent screens of the installation process.
15. At the end of the Windows NT Server 4.0, Enterprise Edition
installation, you have the option of viewing the Error Log. View the log
by clicking on Yes. If you select No, the system reboots.
16. Log on to Windows NT Server 4.0, Enterprise Edition.
17. If you elected to install Compaq Insight Management Agents, a
configuration screen appears. Configure the agents as needed.
18. A prompt to load Service Pack 3 appears. Insert the Microsoft
Windows NT Server 4.0, Enterprise Edition CD #1 and click OK. When
the Confirm File Replace window appears, select No To All.
19. After Service Pack 3 is loaded, remove the CD and click OK. The
system reboots.
20. Log on to Windows NT Server 4.0, Enterprise Edition. Exit the
installation of Enterprise Edition Installer.