Compaq CL380 - ProLiant - 256 MB RAM Software User's Manual page 87

If you are upgrading controller firmware under Novell NetWare 4.2 or
NetWare 5.1, follow the steps in the section titled "Novell NetWare
Firmware Upgrade Procedures."
IMPORTANT: Microsoft Cluster Server under Windows NT Server 4.0, Enterprise Edition,
Cluster Service under Windows 2000 Advanced Server, SNMP service, and any I/O must
be stopped during the firmware update.
8. Restore the controller configuration settings saved in Step 1 using the
Restore Configuration option of the CR3500 Configuration Utility.
9. Power down the shared storage area.
10. Remove the CR3500 RAID Controller blanking panel from
bay 2 (bottom).
11. Insert the original CR3500 RAID Controller into bay 2 (bottom).
12. Power up the shared storage area and verify proper installation and
operation.
NOTE: For more information on the Shared Storage RAID Controller CR3500 LED
diagnostic checks, refer to the Compaq ProLiant CL380 User Guide.
NOTE: After the controllers initialize, the shared storage subsystem will be running in a
redundant controller configuration.
Novell NetWare Firmware Upgrade Procedures
Use the following procedures to upgrade firmware under Novell NetWare 4.2
or NetWare 5.1. Due to the use of a serial interface for firmware updates, this
procedure must be used for each controller as needed.
1. Connect the controller to a system running Microsoft Windows 95, 98,
or NT by means of the serial connector on the back of the shared storage
subsystem.
2. Use a terminal program, such as HyperTerminal, to connect to the host
system.
CR3500 Configuration Utility 4-35