Installing Cluster Service On The Server Nodes - Compaq CL380 - ProLiant - 256 MB RAM Software User's Manual

2-10 Compaq ProLiant CL380 Software User Guide

Installing Cluster Service on the Server Nodes

NOTE: The Shared Storage CR3500 RAID Controller is listed under "Other Devices" in the
Microsoft Windows 2000 Advanced Server Device Manager.
3. After the shared storage drives have been configured, run Disk
Management for Windows 2000 to create volumes out of the logical
drives. Be sure to assign drive letters and format the volumes for NTFS.
NOTE: Do not upgrade the logical drives from Basic to Dynamic. Cluster Service for
Microsoft Windows 2000 Advanced Server does not support dynamic disks.
4. Close Disk Management and restart Windows 2000 Advanced Server.
5. Continue with the system configuration by performing the steps in the
following section, "Installing Cluster Service on the Server Nodes."
1. Install and configure the Cluster Service component of Windows 2000
Advanced Server on node 1.
NOTE: Refer to the Microsoft Windows 2000 Advanced Server documentation for details
on installing and configuring Cluster Service.
2. Optionally, install the latest operating system service pack and restart
the system.
3. If you elected to install the latest operating system service pack, run the
Compaq Support Paq for Windows 2000 to ensure that the latest
Compaq drivers have not been overwritten during the installation of the
service pack.
4. Press Print Screen to access the KVM switch and choose server node 2
from the list.
NOTE: For detailed instructions on using the KVM switch, refer to the
Compaq ProLiant CL380 User Guide.
5. Install and configure the Cluster Service component on node 2.
NOTE: Refer to the Microsoft Windows 2000 Advanced Server documentation for details
on installing and configuring Cluster Service.
6. Optionally, install the latest operating system service pack and restart
the system.