Compaq CL380 - ProLiant - 256 MB RAM Software User's Manual page 31

System Setup and Configuration for Microsoft Windows 2000 Advanced Server 2-3
b. Select Step 3: View or Edit Details.
c. Press the down arrow to select Compaq 64-Bit Dual Channel Wide
Ultra2 SCSI Controller (Port1). Underneath this heading is a
subheading titled SCSI ID.
d. Highlight the SCSI ID option and then press Enter.
e. Set the SCSI ID to 6, then press Enter to accept the change.
f. Press F10 to exit.
g. Select Step 5: Save and Exit, then press Enter and wait for the
Compaq Array Configuration Utility to start.
NOTE: The Compaq Array Configuration Utility configures the Integrated Smart Array
Controller. Refer to the Compaq Integrated Smart Array Controller User Guide for
additional information on using the Compaq Array Configuration Utility.
7. When the Compaq Array Configuration Utility starts, select Continue,
then click Next.
8. Click Next to select a controller configuration.
9. Select the desired RAID level and click Continue.
10. Click Finish.
11. The Product Selection window appears. Continue to follow the guided
installation process, selecting options as needed. If you need help, refer
to the online help by clicking the Help button.
IMPORTANT: Do not install the Cluster Service component of Microsoft Windows 2000
Advanced Server at this time. The Cluster Service component will be added on both nodes
after you configure the shared storage.
When the installation of Windows 2000 Advanced Server is complete,
the system will reboot.
12. Log on to Windows 2000 Advanced Server.
13. If you elected to install Compaq Insight Agents, a configuration screen
appears. Configure the agents as needed, remove the CD, and restart
Windows 2000 Advanced Server.
14. Log on to Windows 2000 Advanced Server and install the Compaq
Support Paq for Windows 2000 located on the SmartStart and Support
Software CD. Accept all devices chosen by the Compaq Support Paq for
Windows 2000 and restart the system when the installation completes.