Computer Setup-Exit - HP 200 G4 22 Maintenance And Service Manual

Table 5-4 Computer Setup—Boot Options (continued)
Option
Legacy Boot Order
Computer Setup—Exit
NOTE: Support for specific Computer Setup options can vary depending on the hardware configuration.
Table 5-5 Computer Setup—Exit
Option
Save Changes and Exit
Ignore Changes and Exit
Load Setup Defaults
Heading
To boot one time from a device other than the default device specified in Boot Order, restart the computer
and press Esc (to access the boot menu) and then
when the monitor light turns green. After POST is completed, a list of bootable devices is displayed. Use
the arrow keys to select the preferred bootable device and press Enter. The computer then boots from the
selected non-default device for this one time.
Specifies the order in which legacy boot sources are checked for a bootable operating system image.
Default is Internal Hard Drive.
IMPORTANT: UEFI boot sources always have precedence over legacy boot sources.
Heading
Saves changes to current system configuration, exits Computer Setup, and reboots.
Exits Computer Setup without applying or saving any changes.
Restores the factory system configuration settings as the default.
F9 (Boot Order), or only F9 (skipping the boot menu)
Computer Setup (F10) utilities 45