Computer Setup-Exit - HP Pro G2 SFF Manual

Table 6-4 Computer Setup–Boot Options menu (continued)
Option
Legacy Boot Order
Computer Setup—Exit
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Table 6-5 Computer Setup–Exit menu
Option
Save Changes and Exit
Ignore Changes and Exit
Load Setup Defaults
Apply Defaults and Exit
Save Current Settings as
Default
Restore Factory Settings
as Default
78 Chapter 6 Computer Setup (F10) Utility
Heading
Up and Down arrow keys select a device.
disabled if the device is marked with an exclamation mark. When Legacy Support is enabled, UEFI boot
order and Legacy boot order are both available and UEFI boot order has higher priority than Legacy boot
order.
Specify the order in which legacy boot sources (such as a network interface card, internal hard drive, USB
optical drive, or internal optical drive) are checked for a bootable operating system image. Each device on
the list may be individually excluded from or included for consideration as a bootable operating system
source.
This option is grayed out if Legacy Support is set to disabled.
NOTE: To drag a device to a preferred place, press Enter. To remove the device from consideration as a
bootable device, press F5.
Heading
Exit System Setup and save your changes.
Exit without saving changes.
Load setup default values for all setup items.
Load default values for all setup items and exit setup and save your changes.
Save current setup settings as the default settings.
Restore factory settings as the default settings
F5 and F6 keys move the device up or down. Boot capability is