Server Does Not Have - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

D-6 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Possible Reasons
Video may not be properly connected.
Switches may not be correctly set on the Server
Feature Board.
If an optional video card was installed, the
monitor cable may not be correctly connected.
The monitor may be connected to the wrong
video connector.
Server Does Not Have Video
WARNING: To reduce the risk of electric shock or damage to the equipment, before opening
access panels to reseat components, power down the server and disconnect the power cord.
CAUTION: When the Pentium III FC-PGA processor is reseated or its heatsink removed, the
thermal seal between the heatsink and processor is broken, the thermal effectiveness of the
heatsink is compromised, and the heatsink must be replaced.
Table D-3
The Next Step
1. Verify that the monitor has power and that the
monitor cable is securely connected. If more
than one video adapter is installed, make sure
that the monitor is connected to the correct
video card.
2. Verify that the monitor is functional by
connecting it to a known working server.
3. Verify that the switch settings on the Server
Feature Board are correctly set.
See Appendix E for switch settings.
4. Power down the server. Reseat all cards and
memory modules, and verify all cable
connections.
See Chapter 3 for bezel and side panel removal.
5. Restart the server.
6. Listen for audible indicators, such as a series of
beeps. A series of beeps indicates the presence
of a Power-On Self-Test (POST) error message.
Refer to the Compaq Servers Troubleshooting
Guide for a complete listing of possible POST
error messages.
7. Refer to "Video Problems" in the Compaq
Servers Troubleshooting Guide.
8. If these steps do not correct the problem,
contact your Compaq authorized service provider
for further technical support.