Rompaq - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

5-12 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

ROMPaq

Preboot Execution Environment (PXE) Options allows the user to
download operating system configurations from the network via the NIC
connector.
I
Embedded PXE Support enables or disables the user's ability to
remote boot from the network via the NIC connector. The default for
this option is disabled.
I
User Interface enables or disables the ability to perform an unattended
network boot via the NIC connector. The default for this option is
enabled.
Set Defaults and Exit allows the user to reset the configuration settings to
their factory defaults.
Utility Language
The Utility Language is used to set the language in which RBSU is displayed.
The user has the following choices:
I
English
I
Spanish
I
German
I
French
I
Italian
I
Japanese
Using Flash ROM in Compaq servers allows the firmware (BIOS) to be
upgraded with system or option ROMPaq utilities. To upgrade the BIOS,
insert a ROMPaq diskette into the diskette drive, remove power from the
system, and then power up the system again.
The ROMPaq utility then checks the system and provides a choice (if more
than one exists) of ROM revisions to which the system can be upgraded. This
procedure is the same for both system and option ROMPaq utilities.
CAUTION: Do not power down during a firmware upgrade. A loss of power
during upgrade may corrupt the firmware and prevent the system from starting.