Switches - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

E-6 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Switches

The ProLiant ML330e/ML330 server contains three switchbanks. Switches on
two of the switchbanks may need to be changed from time to time. If they are
not correctly set, problems will occur. This chapter explains the use of each
nonreserved switch.
I
The system configuration switch (SW2) is located on the system board.
You may use it to perform the following:
G
Enable or disable power-up password protection.
G
Clear all system configuration information from CMOS and
nonvolatile RAM (NVRAM).
G
Enable or disable ROMPaq disaster recovery mode (also known as
emergency repair boot mode).
I
The reserved processor switch (SW1) is located on the system board.
The function of SW1 is not applicable to the ProLiant ML330e/ML330
server.
I
The Server Feature Board switch allows you to enable or disable
embedded video. Some switches are reserved for the use of Compaq
authorized service providers only.
IMPORTANT: Reserved switches are provided for use by Compaq authorized service
providers only and must not be changed from the indicated default settings.