Installing A Tape Drive Or Other Device Into A Removable Media Bay - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

Installing a Tape Drive or Other Device into a
Removable Media Bay
IMPORTANT: The following section applies only to the ProLiant ML330 server or ProLiant
ML330e server models with a SCSI option card installed.
All ProLiant ML330e/ML330 server models ship standard with four
removable media bays. The top 5.25-inch bay is occupied with an IDE
CD-ROM drive. The remaining three 5.25-inch bays are available for
removable media devices. You can install three half-height devices, or one
full-height device and one half-height device, into these bays.
To install a 5.25-inch device:
IMPORTANT: When installing a removable media device, remove the rails included in the
drive tray and install them on the device (replace any existing rails on the device). The
rails are secured to the drive tray with two screws on each rail.
1. Follow the steps in "Removing the Access Panel" and "Removing the
Bezel Blanks" at the beginning of this chapter.
2. Set the SCSI ID on the drive. You must manually set the SCSI ID on
each device to a unique value in the range of 0 to 6 for each SCSI bus.
Refer to the documentation provided with the device for instructions on
how to set the SCSI ID.
3. Remove all terminating jumpers from third-party SCSI devices.
(Compaq SCSI cables are terminated.)
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
Hardware Options Installation 3-15