Server Does Not Have - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

WARNING: To reduce the risk of electric shock or damage to the equipment, before opening
access panels to reseat components, power down the server, and then disconnect the power
cord.
Note: For LED locations and functions, as well as switch setting information, see Appendix E, "LED
Indicators, Switches, and Jumpers."
Possible Reasons
Video may not be properly
connected.
Switches may not be correctly set
on the system board.
If an optional video card was
installed, the monitor cable may not
be correctly connected.
The monitor may be connected to
the wrong video connector.
Expansion boards or DIMMs may
not be properly connected or
seated.
Table D-3
Server Does Not Have Video
The Next Step
1. Verify that the monitor has power and that the monitor cable
is securely connected. If more than one video adapter is
installed, make sure that the monitor is connected to the
correct video card.
2. Verify that the monitor is functional by connecting it to a
known working server.
3. Verify that the switch settings on the system board are
correctly set.
4. Power down the server. Reseat all expansion boards and
DIMMs, and then verify all cable connections.
See Chapter 3, "Hardware Options Installation," for bezel
and side panel removal.
5. Restart the server.
6. Listen for audible indicators, such as a series of beeps. A
series of beeps indicates the presence of a POST error
message.
Refer to the Compaq Servers Troubleshooting Guide for a
complete listing of possible POST error messages.
7. Check the diagnostic LEDs on the system board for failure
conditions.
8. Refer to "Video Problems" in the Compaq Servers
Troubleshooting Guide.
If these steps do not correct the problem, contact your Compaq
authorized service provider for further technical support.
Troubleshooting D-7