Dell 2150CN User Manual page 300

IPv4 Get IP Address AutoIP
IP Address
Subnet Mask
Gateway Address
IPsec Disable
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the
printer is turned off and then on again.
Values:
298
Understanding the Printer Menus
*
BOOTP
RARP
DHCP
Panel
*
Sets the IP address automatically. A random
value in the range of 169.254.1.0 to
169.254.254.255 that is not currently in use
on the network is set as the IP address. The
subnet mask is set as 255.255.0.0.
Sets the IP address using BOOTP.
Sets the IP address using RARP.
Sets the IP address using DHCP.
Use this option when you want to set the IP
address manually on the operator panel.
When an IP address is being set manually, the
IP is allocated to the printer using the format
nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0
to 254. 127 and any value in the range of 224
to 254 cannot be specified for the first octet
of a gateway address.
When an IP address is being set manually, the
subnet mask is specified using the format
nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0
to 255. 255.255.255.255 cannot be specified
as the subnet mask.
When an IP address is being set manually, the
gateway address is specified using the format
nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0
to 254. 127 and any value in the range of 224
to 254 cannot be specified for the first octet
of a gateway address.
Disables IPsec.