ACME STAGE PAR 100 IP Instruction Manual page 11

Addr (DMX Address)
Select Addr, press ENTER.
Use UP/DOWN button to select an address between 1 and 512, confirm
your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
ChMd (Channel Mode)
Select ChMd, press ENTER.
Use UP/DOWN button to select between 1 Ch, 2 Ch and 3 Ch, confirm
your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
DiMd (Dimmer Mode)
Select DiMd, press ENTER.
Use UP/DOWN button to select di 1 (dimmer mode 1), di 2 (dimmer
mode 2), di 3 (dimmer mode 3) or di 4 (dimmer mode 4), confirm your
selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
DimS (Dimmer Speed)
Select DimS, press ENTER.
Use UP/DOWN button to select Fast or Smoo (Smooth), confirm your
selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
DmSt (DMX Status)
Select DmSt, press ENTER.
Use UP/DOWN button to select one of the following status:
BlMd (Blackout Mode: Fixture blacks out if DMX signal stops)
Hold (The device continues to operate in the current mode with the last
active DMX values until the signal returns)
Confirm your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
- 10 -
REV F 02/07/2025