Removing The Peripheral Bay Panel (Tower Only); Installing The Peripheral Bay Panel (Tower Only) - Dell POWER EDGE 2900 Hardware Owner's Manual

Removing the Peripheral Bay Panel (Tower Only)

NOTE:
The peripheral bay panel can be removed only from inside the bezel.
1 With the bezel removed from the system, place the bezel face-down on a flat working surface.
2 Locate the release tabs inside the bezel at the bottom of the peripheral bay panel and press in on the
tabs and push forward to slide the panel outward from the bezel. See Figure 3-3.
3 Remove the panel from the front side of the bezel.
4 Reinstall the bezel on the system. See "Installing the Bezel" on page 53.
Figure 3-3. Installing and Removing the Peripheral Bay Panel (Tower)
1 tower bezel with peripheral
bay panel
4 bezel (inside view)

Installing the Peripheral Bay Panel (Tower Only)

1 With the bezel installed on the system, align the peripheral bay panel with the panel opening on
the bezel and insert the panel, tab-end first, into the opening.
2 Slide the panel downward so that the tabs enter the slots in the bezel and lock into position.
52
Installing System Components
1
2 peripheral bay panel
5 tab slot (2)
2
3
4
5
3 tab (2)