Figure 3-32. Removing the Control Panel Assembly
2
1
8
1
display module screws (2)
4
control panel board
7
system chassis
Installing the Control Panel Assembly
The following procedure applies to either a rack or tower system. Figure 3-32 illustrates a control panel
assembly in the rack orientation.
1 Insert the control panel assembly display module into the chassis cutout and secure with the two Torx
screws.
2 Affix the control panel label to the display module.
3 Install the control panel board in the system chassis and secure with the three Phillips screws. See
Figure 3-32.
4 Connect the display module ribbon cable to the control panel board. See Figure 3-32.
106
Installing System Components
4
3
2
display module
5
control panel cable
8
display module label
5
7
3
display module cable
6
screws (3)
6