Dell POWER EDGE 2900 Hardware Owner's Manual page 22

Table 1-6. LCD Status Messages (continued)
Code Text
E1712 PCI SERR B## D##
F##
PCI SERR Slot #
E1714 Unknown Err
E171F PCIE Fatal Err
B## D## F##
PCIE Fatal Err
Slot #
E1810 HDD ## Fault
HDD ## Rbld Abrt The specified hard drive has
E1811
E1812 HDD ## Removed
E1913 CPU & Firmware
Mismatch
E1A10 PBD Pwr Cable
22
About Your System
Causes
The system BIOS has reported a
PCI system error on a component
that resides in PCI configuration
space at buss ##, device ##,
function ##.
The system BIOS has reported a
PCI system error on a component
that resides in slot #.
The system BIOS has determined
that there has been an error in the
system, but is unable to
determine its origin.
The system BIOS has reported a
PCIe fatal error on a component
that resides in PCI configuration
space at bus ##, device ##,
function ##.
The system BIOS has reported a
PCIe fatal error on a component
that resides in slot #.
The SAS subsystem has
determined that hard drive ##
has experienced a fault.
experienced a rebuild abort.
The specified hard drive has been
removed from the system.
The BMC firmware does not
support the CPU.
The power distribution board
power cable is unseated, missing,
or bad.
Corrective Actions
Remove and reseat the PCI
expansion cards. If the problem
persists, see "Troubleshooting
Expansion Cards" on page 131.
If the problem persists, the
system board is faulty. See
"Getting Help" on page 147.
See "Getting Help" on page 147.
Remove and reseat the PCI
expansion cards. If the problem
persists, see "Troubleshooting
Expansion Cards" on page 131.
If the problem persists, the
system board is faulty. See
"Getting Help" on page 147.
See "Troubleshooting a Hard
Drive" on page 129.
See "Troubleshooting a Hard
Drive" on page 129. If the
problem persists, see your RAID
documentation.
Information only.
Update to the latest BMC
firmware. See the BMC User's
Guide for more information on
setup and use of BMC.
Ensure that the power
distribution board power cable is
seated properly. If the problem
persists, replace the power
distribution board power cable.
See "Installing the Power
Distribution Board" on page 112.