Dell POWER EDGE 2900 Hardware Owner's Manual page 23

Table 1-6. LCD Status Messages (continued)
Code Text
E1A14 SAS Cable A
E1A15 SAS Cable B
E1A16 SAS Cable FB
E1A17 Pwr Cable FB
E1A18 PDB Ctrl Cable
E2010 No Memory
E2011 Mem Config Err
E2012 Unusable Memory
Shadow BIOS Fail The system BIOS failed to copy
E2013
E2014 CMOS Fail
E2015 DMA Controller
E2016 Int Controller
Causes
SAS cable A is unseated, missing,
or bad.
SAS cable B is unseated, missing,
or bad.
Flex bay SAS cable is unseated,
missing, or bad.
Flex bay power cable is unseated,
missing, or bad.
The power distribution board
control cable is unseated,
missing, or bad.
No memory is installed in the
system.
Memory detected, but is not
configurable. Error detected
during memory configuration.
Memory is configured, but not
usable. Memory subsystem
failure.
its flash image into memory.
CMOS failure. CMOS RAM not
functioning properly.
DMA controller failure.
Interrupt controller failure.
Corrective Actions
Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
Check the power cable
connection to the flex bay
backplane. See "Installing the 1x2
Flex Bay Drive Bracket" on
page 95.
Ensure that the power
distribution board control cable is
seated properly. If the problem
persists, replace the power
distribution board control cable.
See "Installing the Power
Distribution Board" on page 112.
Install memory. See "Memory" on
page 82.
See "Troubleshooting System
Memory" on page 124.
See "Troubleshooting System
Memory" on page 124.
See "Troubleshooting System
Memory" on page 124.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
About Your System
23