Dell POWER EDGE 2900 Hardware Owner's Manual page 24

Table 1-6. LCD Status Messages (continued)
Code Text
E2017 Timer Fail
E2018 Prog Timer
E2019 Parity Error
E201A SIO Err
E201B Kybd Controller
E201C SMI Init
E201D Shutdown Test
E201E POST Mem Test
E201F DRAC Config
E2020 CPU Config
E2021 Memory
Population
E2022 POST Fail
MBE DIMM ## & ## One of the DIMMs in the set
E2110
E2111 SBE Log Disable
DIMM ##
24
About Your System
Causes
Timer refresh failure.
Programmable interval timer
error
Parity error.
SIO failure.
Keyboard controller failure.
System management interrupt
(SMI) initialization failure.
BIOS shutdown test failure.
BIOS POST memory test failure. See "Troubleshooting System
Dell remote access controller
(DRAC) configuration failure.
CPU configuration failure.
Incorrect memory configuration.
Memory population order
incorrect.
General failure after video.
implicated by "## & ##" has
had a memory multi-bit error
(MBE).
The system BIOS has disabled
memory single-bit error (SBE)
logging, and will not resume
logging further SBEs until the
system is rebooted. "##"
represents the DIMM implicated
by the BIOS.
Corrective Actions
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
Memory" on page 124. If problem
persists, see "Getting Help" on
page 147.
Check screen for specific error
messages.
Ensure that DRAC cables and
connectors are properly seated. If
problem persists, see your DRAC
documentation.
Check screen for specific error
messages.
Check screen for specific error
messages. See "Troubleshooting
System Memory" on page 124.
Check screen for specific error
messages.
See "Troubleshooting System
Memory" on page 124.
See "Troubleshooting System
Memory" on page 124.