Dell POWER EDGE 2900 Hardware Owner's Manual page 38

Table 2-2. System Setup Program Options (continued)
Option
SATA Port X
Boot Sequence
USB Flash Drive Type
(Auto default)
Integrated Devices
PCI IRQ Assignment
Serial Communication
Embedded Server
Management
System Security
Keyboard NumLock
(On default)
Report Keyboard Errors
(Report default)
Asset Tag
38
Using the System Setup Program
Description
Displays type and capacity of SATA drive attached to Port X on the system board.
Determines the order in which the system searches for boot devices during system
startup. Available options can include the diskette drive, CD drive, hard drives, and
network.
NOTE:
System boot is not supported from an external device attached to a SAS or
SCSI adapter. See support.dell.com for the latest support information about booting
from external devices.
Determines the emulation type for a USB flash drive. Hard disk allows the USB
flash drive to act as a hard drive. Floppy allows the USB flash drive to act as a
removal diskette drive. Auto automatically chooses an emulation type.
See "Integrated Devices Screen" on page 40.
Displays a screen to change the IRQ assigned to each of the integrated devices on
the PCI bus, and any installed expansion cards that require an IRQ.
Displays a screen to configure serial communication, external serial connector, fail-
safe baud rate, remote terminal type, and redirection after boot.
Displays a screen to configure the front-panel LCD options and to set a user-
defined LCD string.
Displays a screen to configure the system password and setup password features.
See "Using the System Password" on page 43 and "Using the Setup Password" on
page 45 for more information.
Determines whether your system starts up with the NumLock mode activated on
101- or 102-key keyboards (does not apply to 84-key keyboards).
Enables or disables reporting of keyboard errors during the POST. Select Report for
host systems that have keyboards attached. Select Do Not Report to suppress all
error messages relating to the keyboard or keyboard controller during POST. This
setting does not affect the operation of the keyboard itself if a keyboard is attached
to the system.
Displays the customer-programmable asset tag number for the system if an asset
tag number has been assigned.