Dell POWER EDGE 2900 Hardware Owner's Manual page 30

Table 1-7. System Messages (continued)
Message
No boot device available
No boot sector on hard
drive
No timer tick interrupt
Northbound merge error -
The following DIMM has
been disabled by BIOS:
DIMM x
Not a boot diskette
PCIe Degraded Link Width
Error: Embedded
Bus# nn /Dev# nn /Func n
Expected Link Width is n
Actual Link Width is n
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
PCIe Training Error:
Embedded
Bus# nn /Dev# nn /Funcn
PCIe Training Error:
Slot n
30
About Your System
Causes
Faulty or missing optical/diskette
drive subsystem, hard drive, or hard-
drive subsystem, or no boot disk in
drive A.
Incorrect configuration settings in
System Setup program, or no
operating system on hard drive.
Faulty system board.
The specified DIMM was unable to
establish a successful data link with
the memory controller.
No operating system on diskette.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
Corrective Actions
Use a bootable diskette, CD, or hard
drive. If the problem persists, see
"Troubleshooting a Diskette Drive" on
page 126, "Troubleshooting an Optical
Drive" on page 127, and
"Troubleshooting a Hard Drive" on
page 129. See "Using the System Setup
Program" on page 35 for information
about setting the order of boot devices.
Check the hard-drive configuration
settings in the System Setup program.
See "Using the System Setup Program"
on page 35. If necessary, install the
operating system on your hard drive. See
your operating system documentation.
See "Getting Help" on page 147.
See "Troubleshooting System Memory"
on page 124.
Use a bootable diskette.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 68. If the problem persists, see
"Getting Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 68. If the problem persists, see
"Getting Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 68. If the problem persists, see
"Getting Help" on page 147.