1x8 Plus 1x2 Drive Configuration
If the optional 1x2 SAS backplane is installed in the flex bay, make the following cable connections:
•
Connect SAS_0 on the SAS controller daughter card to connector SAS_A on the 1x8 SAS
backplane board. See Figure 3-31.
•
Connect SAS_1 on the SAS controller daughter card to SAS_B_IN on the 1x2 SAS backplane
board. See Figure 3-31.
•
Connect SAS_B_OUT on the 1x2 SAS backplane board to connector SAS_B on the 1x8 SAS
backplane board. See Figure 3-31.
Installing System Components
103