Wired controller - SAVA X
EN
INSTALLATION ACCESSORY
4. PRECAUTION OF INSTALLINGTHE WIRE CONTROLLER
1. This manual provides the installation method of wired controller. Please refer to
the wiring diagram of this installation manual to connect the wire controller with
indoor unit.
2. The wired controller works in low voltage loop circuit. Forbid to directly contact the
cable of high voltage above, like 115V,220V,380V, and don't wire this kind of wire in
the said loop; wiring clearance between congured tubes should be at the range of
300~500mm or above.
3. The Shielded wire of the wired controller must be grounded rmly.
4. Upon nish the wire controller connection, do not employed tramegger to detect
the insulation.
• The wiring should adapt to the wire control current.
Otherwise, electric leakage or overheating may occur and
result in re.
• The speci ed cables shall be used in the wiring. No external
force may be applied to the terminal. Otherwise, the wire may
be damaged and heating may occur and result in re.
12
Installation and Owner's Manual
WARNING
Need help?
Do you have a question about the AKC SAVA X and is the answer not in the manual?