Rotenso AKC SAVA X User Manual page 160

Wired controller - SAVA X
EN
QUERIES AND SETTINGS
After the wire controller resumes the factory parameter setting, the rotating parameter
setting is restored to 10 hours (the highest and lowest temperature are not set);
The compensation of body temperature is uncompensated; COOL and HEAT/single
COOL mode is restored to COOL and HEAT model;
Restore the temperature range to the factory setting.
Remote receiving function is restored to be eective;
The address of the two-control rst-line controller is restored to the code switch.
Set Day O to Automatically Start on Power On:
1. Use the up or down key to select dy:1, displaying the current setting value.
2. Press the conrm key to enter the option for enabling the Day O auto-start
function. The setting value will start ashing.
3. Use the up or down key to change the setting value. A value of 1 enables the
function, while a value of 0 disables it.
4. Press the conrm key to apply the setting. This will take you to the maximum timer
setting option for Day O, dy:2, displaying the current setting value. The value
represents the timer duration in hours, with increments of 0.5 hours.
5. Use the up or down key to change the setting value.
6. Press the conrm key to apply the setting and complete the conguration.
Note: Once the Day O auto-start function is enabled, the device will automatically start
the Day O function with the last set timer duration each time it is powered on.
64
Installation and Owner's Manual