Oracle Roving Edge Device Compute Setup Manual page 5

Setting Up Oracle Roving Edge Device
No. Item
3
USB-to-DB-9 serial cable
For devices with ruggedized cases, the cable is in a pouch inside the rear of the case.
4
AC power cord
For devices with ruggedized cases, the power cord is in a pouch inside the rear of the case.
What's next?
• If your device is inside a ruggedized case, see
• If the device isn't in a ruggedized case, install your device in a rack. See
7.
Remove the Ruggedized Case End-Caps
If the Roving Edge Device is in a ruggedized case, you must remove the front and rear end-caps to access the cable
connectors. The end-caps remain removed during operation.
Caution:
Don't remove the Roving Edge Device from the case. Doing so can damage
the device.
Caution:
Leave the end-caps removed during operation to ensure adequate airflow.
Reinstall the end-caps only when the device is powered down.
1. On the front and rear of the ruggedized case, find the 16 wing-turn latches.
Note: The rear end-cap has casters.
2. Open all 16 wing-turn latches on the front and rear of the case by lifting the latch then turning the latch
counterclockwise.
Oracle Cloud Infrastructure Roving Edge Device Setup Guide
Remove the Ruggedized Case End-Caps
Mount the Device in a Rack
on page 5.
on page
5