Connecting An External Vga Monitor - NEC Generation N3000 M760s User Manual

Connecting an External VGA Monitor

Discovering Your Computer You can add a standard external monitor to your notebook system using a display signal cable (usually
provided with the monitor). One end of the cable must have a 15-pin connector for the system.
Connect an external monitor to your system as follows.
1.
Check that the notebook computer is powered off and the monitor power switch is turned off.
2.
Attach the 15-pin cable connector to the monitor port on the system. Secure the cable connection with
the screws provided.
3.
Connect the monitor power cable and plug it into a properly grounded wall outlet.
4.
Follow any set-up instructions in the monitor's user's guide.
5.
Turn on power to the system and device.
6.
Press the relevant function key to toggle through the video modes.
Refer to "Keyboard"
More information in
© 2007-2009, NEC Computers S.A.S. All rights reserved.
Figure 17: Connecting an external VGA monitor
for more information on the function keys.
"Configuring the Display Settings with SiS VGA Control
Discovering Your Computer
Center".
51