Keysight E4981B User Manual page 151

Using Handler Interface
Control/Check the Handler Interface for Maintenance
•
•
For more information about Handler Test commands, refer to the Keysight
E4981B Programming Manual.
Ending Handler interface test
When the Handler interface test is finished, close the E4981B Handler
interface test mode by setting :TEST:HANDler:MODE command value to OFF
so that handler interface pin signal is generated according to the actual
measurement result.
Keysight E4981B 120 Hz/1 kHz/1 MHz Capacitance Meter
:TEST:HANDler:STATus:RDYTrig sets the Handler Ready for Trigger signal to
HIGH/LOW.
:TEST:HANDler:TRIGger? gets the Handler Trigger signal status as
HIGH/LOW.
151