Remove the screw securing the memory module panel and remove
6.
the panel.
7.
Locate an empty module slot. If you need to remove one or both
modules, see "Removing a SO-DIMM Module" in the next section.
discharge by touching a metal part on the system unit.
Install the SO-DIMM module as follows (see the following figure).
8.
Align the notch in the module with the key in the empty slot.
!
Hold the module at a 45-degree angle and insert it into the slot.
!
Firmly push the module into the socket.
!
!
Press down on the edge of the module until the plastic retaining
clips snap into place.
Installing the SO-DIMM module
A – SO-DIMM Module
B – Notch
Install the SO-DIMM module panel and retaining screw.
9.
10.
Plug in the AC adapter power cord and press the power switch.
5-10 Adding Expansion Devices
Before you install a SO-DIMM, reduce static
C – Socket Key
D – Plastic Retaining Clip (2)