NEC Image P100E Series Manual page 90

9. When you are done, press
remove boards" configuration procedure.
Before you exit, note information you might need to
change settings or install boards. To print out any con-
figuration information about the board, select "Step 4:
Examine Required Switches."
Repeat steps 1 through 9 in the above procedure to add
another board.
Step 3: View or Edit Details
Select Step 3 to modify system board settings or to config-
ure your system when you are setting up for the first time.
System board settings include the following configuration
categories:
System and video BIOS caching, and system and video
BIOS shadowing
Port configurations — parallel port, serial
port 1, and serial port 2 addresses and interrupts.
Peripheral controllers — diskette drive controller, PCI
SCSI controller, PCI IDE controller, PCI VGA
controller.
Refer to the following table for a quick-reference list of
ECU utility parameters and their factory (default) settings.
See the procedure and additional information following the
table to configure your system board.
F10 to exit "Step 2: Add or
Using the ECU and SCSI Utilities 4-15