Table of Contents
Advertisement
You may have to remove any installed expansion boards
4.
to access the jumper (see "Removing an Expansion
Board" in Chapter 5).
5.
Remove the jumper block from pins 1-2 and set it on
pins 2-3. We recommend that you use needle nose pliers
to move a jumper.
Replace the access cover (see "Replacing the Access
6.
Cover" in Chapter 5).
Connect system power cables and monitor.
7.
Power on the system.
8.
The system enters Setup and the Maintenance menu
appears. You can disable the user and supervisor
passwords.
If you removed the jumper, the system attempts to
recover the BIOS. A recovery diskette is needed.
Power off, unplug the system and monitor, and remove
9.
the access cover.
Remove the jumper block from pins 2-3 and replace it
10.
on pins 1-2.
If you removed any expansion boards, replace them
11.
(see "Installing an Expansion Board" in Chapter 5).
Replace the access cover. Reconnect the system power
12.
cables and peripheral devices.
Power on the system.
13.
Run Setup (see Chapter 4, System BIOS and Utilities).
14.
Setting System Board Jumpers 6-3
Advertisement
Table of Contents
