Table of Contents
Advertisement
RECOVERING THE BIOS
The following sections describe how to recover the system
BIOS.
Turn off the power and unplug the system and any
1.
peripherals.
Turn off the system before you change any jumper
settings.
2.
Remove the access cover (see "Removing the Access
Cover" in Chapter 5).
3.
Locate the Configuration jumper (J8B2) on the system
board (see "Locating the Jumper" in the previous
subsection).
You may have to remove any installed expansion boards
4.
to access the jumper (see "Removing an Expansion
Board" in Chapter 5).
Remove the jumper block from pins 1-2. We recommend
5.
that you use needle nose pliers to move a jumper.
6.
Replace the access cover (see "Replacing the Access
Cover" in Chapter 5).
7.
Connect system power cables and monitor.
Power on the system.
8.
The system attempts to recover the BIOS. A recovery
diskette is needed.
Power off, unplug the system and monitor, and remove
9.
the access cover.
6-4 Setting System Board Jumpers
!
WARNING
Advertisement
Table of Contents
